The original fence was put in around 1984 with the help of the Manpower Services (a Government scheme set-up to help people into employment) to help stabilise the scree around the footpath. After we replaced the pitching next to the plantation in 2009 we planted up a few more trees, with the help of the Fix the Fells volunteers, but as time went by it's become easier for sheep to get in and graze on the trees. We therefore decided that the fence should be replaced and all the materials were flown to site earlier on in the year. Long-term it's hoped that once everything is properly established the fence can eventually be removed.
The first job was to work out exactly where the fence line should go. With the ground being extremely undulating with lots of large boulders and trees to work around it took a bit of time to decide on the best line.
Finding the best line
With this done it was time to start digging the hole for the straining post. A hole is dug to a depth the height of a shovel, the post is placed into the hole and rock is compacted tightly around it. This makes sure they are solidly in the ground as the wire fencing is strained off these posts so there's a lot of force on them, and you don't want them moving.
Finishing the hole for the straining post
With the post in the ground, a single wire is tightened between two "strainers" to give a straight line between the posts. A strut is then added to give the post even more strength, this strut runs parallel to the wire. A section of wood is then chiseled out of the straining post that the strut neatly fits into. The other end is dug into the ground and again tightened using rock.
Putting in the strut
With the post properly secured the next job is to knock in the fence posts at equal intervals along the length of the wire. Once this is done the Rylock stock fencing is stapled to one of the strainers and then strained from the other.
Attaching the fence